TELEDYNE OLDHAM SIMTRONICS OLCT 80 d, User Manual

Page: 70 / 116

OLCT 80
GAS TRANSMITTER
USER MANUAL
64 NPO80GB
Revision F.1
Figure 52: buttons and indicator lights on the master receiver.
Follow the steps below:
1. Check that the addresses have been configured properly (rotary switches,
OLCT 80
wireless cards (Figure 50, A and B) and
master receiver wireless cards (Figure 52, D).
2. Turn on power to the OLCT 80s and the master receiver.
3. On the master receiver (see: Figure 52: buttons and indicator lights on the master
receiver.press three times fast on the button marked "E" in the figure.
The two LEDs (B and F) blink on and off in red and the LCD screen (C) displays the words
"
BINDING" and " MASTER."
4. On the OLCT 80 wireless card (see Figure 53: OLCT 80 wireless card.press three times
fast on the coupling button marked "A" in the figure.
The LED (B) will change from red to green and then orange for 4 seconds before blinking
4 times to indicate that it has found the master receiver. Once the coupling code
transmitted by the
master receiver is received, the wireless card will automatically exit
coupling mode.
Figure 53:
OLCT 80
wireless card.
5. Repeat step 4 for each OLCT 80.
6. Once all of the wireless codes are coupled, leave coupling mode on the master receiver
by pressing twice on the button marked "E" in Figure 52.
In normal operating mode, the LED (Figure 53, B) of the OLCT 80 's wireless card blinks
orange, while the LED (Figure 52, F) of the master receiver blinks red.
7. Close the housings
The
OLCT 80s must be at least 2 meters away from the master receiver.