TELEDYNE OLDHAM SIMTRONICS OLCT 80 d, User Manual

Page: 69 / 116

OLCT 80
GAS TRANSMITTER
USER MANUAL
NPO80GB
Revision F.1
63
The @50 address is reserved for the master receiver.
5.6.2 Configuring the addresses of the OLCT 80's wireless cards
To configure the address of the
OLCT 80's wireless card, move the 10s-place switch (B) and the
1s-place switch (A) to the desired values (i.e., 51 in the case of the example above).
Figure 50: configuring the address of the wireless card.
5.6.3 Configuring the addresses on the
master
receiver
Selecting the address for the master receiver wireless cards
The
master receiver's address must be set to @50.
Figure 51: configuring the
master
receiver's address to @50.
5.7 Start-up
Follow safety rules for opening explosion-proof equipment (hot-work permit,
etc.) when powering and coupling the system.