TELEDYNE API T100U, Addendum To The Operation Manual

Page: 9 / 66

7
1. PREFACE
Note The information contained in this addendum is pertinent to T100U
analyzers running software revision Gc4. Some or all of the information
may not be applicable to later revisions of software. The software
revision that your analyzer is running is displayed in the Mode field of the
display any time the analyzer is in SETUP mode.
This addendum is based on the Model T100 Operators Manual (P/N 06807). In most
ways the T100U is identical to the T100 in design and operation; therefore, most of the
basic set up information, operating instructions as well as calibration, maintenance,
troubleshooting and repair methods are found in that manual. This addendum
documents only those areas where the T100U is different in design or operating method
from the T100.
Therefore, this addendum includes instructions and information regarding:
•
Additional Test Functions
•
Adjusting the PMT HV for “Factory Calibrations”
•
Differences in theory of operation
1.1 REFERENCE NUMBERING CONVENTION
Unless otherwise specified, section, figure and table reference numbers referred to
within this text are relative to this manual.
EXAMPLE: “Figure 2-1” refers to the figure within this document labeled as
Figure 2-1.
References to sections, figures and tables in the T100 manual will be labeled as such.
EXAMPLE: “Figure 6-1 of the T100 Operators Manual” (P/N 06807).
06840B DCN 6201