REDIAL
To redial the last telephone number dialed:
Lift the handset or press SPEAKERPHONE key and press REDIAL.
HANDSET VOLUME KEY
The HANDSET VOLUME key has three levels. When the handset is first lifted, the handset volume is normal.
Locate the HANDSET VOLUME key to the right of the keypad. Press the key once and the volume level will increase
one level (to med. volume). Press the key once more and the volume level will increase an additional level (to high
volume). To return the handset volume to normal volume, press the handset volume key again.
AUTO DIAL KEYS
The Diamond L2S-10E has ten (10) programmable AUTO DIAL keys and the L2S-5E has five (5). These keys can
be programmed to automatically dial telephone numbers, or activate telephone system features.
Storing Auto Dial Keys:
The telephone must be connected to a telephone line.
1. Lift the handset or press the SPEAKERPHONE key.
2. Press the recessed STORE key and release it (Please see diagram on page 6 for key location).
3. Enter the telephone number including PAUSE* as required. The sequence can be up to 15 digits.
4. Press the AUTO DIAL key where the number is to be stored.
5. Hang up the handset or press the SPEAKERPHONE key to disconnect.
*A 3.6 second pause is entered in a dialing sequence by pressing the REDIAL key for each PAUSE required.
CONVERTING FROM DESK TO WALL MOUNT
The Elite can be changed for wall mounting applications. The conversion is easiest when the handset and line cords are
not connected.
1. Located on the front of the telephone above the speaker grill is the wall/desk mount clip. Remove this clip by firmly
pushing upward (towards the hook switch).
2. Rotate the clip a half turn (180 degrees) so that the side with the protruding edge is towards the top. This edge will
hold the handset.
3. Turn the phone over so the back side is up facing you. Use a non abrasive surface to prevent scratching.
4. Locate and remove the mounting bracket, firmly push back and pull up to remove two of the four retaining tabs.
5. Rotate the mounting bracket a half turn (180 degrees) so that the mounting eyelet is facing in the same direction as the
other mounting eyelet located on the lower part of the telephone.
