INCLUDED IN YOUR PACKAGE
Handset
Base
Coiled Handset Cord
Line Cord
Clear Plastic Overlay
User Guide
CONNECTING THE DIAMOND Elite
1. Located on the left side of the Diamond Elite is a modular jack labeled TO HANDSET. Insert one end of the coiled
handset cord into this jack (you should hear the coil cord click when properly inserted).
2. Insert the other end of the coiled handset cord into the modular jack on the handset.
3. Turn the telephone so the back panel is facing you. Insert either end of the line cord into the jack on the back of the
telephone labeled TO TEL.
4. Insert the other end of the line cord into a telephone wall outlet jack.
5. Once your telephone is connected, place the paper faceplate over the keys. The plastic overlay slips into place by
hooking the tabs on the overlay into the recessed slots located on both sides. The overlay is easiest to insert when; the
left or right side tabs are inserted first, and the middle of the overlay is slightly bowed to allow for insertion of the other
tabs.
SELECTING LINE 1 AND LINE 2
The Elite L2S MPC technology makes selecting the correct line as easy as lifting the handset. The MPC technology
prioritizes the ringing or idle line reducing the confusion of line selection.
PLACING A CALL
Using the Handset
1. Lift the handset. The Elite will select the appropriate “idle” line.
2. Listen for dial tone. Dial the desired number, or press an AUTO DIAL key to automatically dial a number.
3. To end the call, hang up by replacing the handset.
Using the Speakerphone
1. With the handset in the cradle press the LINE 1 or LINE 2 keys. The Elite will go off hook on the selected line with
speakerphone active.
OR
Press the SPEAKER key. The Elite will select the appropriate “idle” line.
NOTE: The red SPEAKER LED will indicate that the speakerphone is active.
2. Listen for dial tone, dial the desired number, or press an AUTO DIAL key to automatically dial a number.
3. To end call the call press the SPEAKER key again.
