background image

  its slot.This edge will hold the handset when the phone  
  is mounted on the wall.
3. Turn the telephone over so the bottom is up, facing you.
  Place it on a non-abrasive surface to prevent scratching.
4. Locate and remove the mounting bracket. Firmly push back
  and pull up to remove two of the four retaining tabs.
5. Rotate the mounting bracket 180º degrees clockwise, so
  that the mounting eyelet on the bracket is facing in the     
  same direction as the other mounting eyelet located on the
  bottom of the telephone.
6. Insert the top two retaining tabs of the mounting brackets
  into the mounting bracket slots (located near the middle  
  of the telephone). Then firmly push down to insert  
  the retaining tabs on the opposite side of the  
  mounting bracket.
7. Connect a 15-foot RJ-45 cord into the LINE jack on the back
  of the phone.
8. Turn the telephone over, and slide the telephone down     
  onto the mounting posts of the wall bracket. Ensure  
  that both eyelets line up with the mounting posts.

The Ringer Equivalence Number (REN) of this device is 0.7B.
Notice: The Ringer Equivalence Number (REN) assigned to each 
terminal device provides an indication of the maximum number of 
terminals allowed to be connected to a telephone interface. The  
termination on an interface may consist of any combination of 
devices subject only to the requirement that the sum of the Ringer 
Equivalence Numbers of all the devices does not exceed 5. This 
telephone connects to the telephone network under the connecting 
arrangement code CA11A.

IMPORTANT SAFETY INSTRUCTIONS
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY  
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE  
THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS,  
INCLUDING THE FOLLOWING:
1.  READ AND UNDERSTAND ALL INSTRUCTIONS.
2.  FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED  
  ON THE PRODUCT.
3.  UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE  
  CLEANING. DO NOT USE LIQUID CLEANER OR AEROSOL CLEANERS.  
  USE A DAMP CLOTH FOR CLEANING.
4.  DO NOT USE THIS PRODUCT NEAR WATER, FOR EXAMPLE, NEAR 
  A BATHTUB, WASH BOWL, KITCHEN SINK OR LAUNDRY TUB, IN A  
  WET BASEMENT, OR NEAR A SWIMMING POOL.
5.  DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND OR  
  TABLE. THE PRODUCT MAY FALL, CAUSING SERIOUS DAMAGE TO  
  THE PRODUCT.
6.  SLOTS AND OPENINGS IN THE CABINET AND THE BACK OF 
  BOTTOM ARE PROVIDED FOR VENTILATION, TO PROTECT IT FROM  
  OVERHEATING. THESE OPENINGS MUST NOT BE BLOCKED OR 
  COVERED. THE OPENINGS SHOULD NEVER BE BLOCKED BY 
  PLACING THE PRODUCT ON THE BED, SOFA, RUG OR ANY OTHER
  SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED      
  NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS PRODUCT  
  SHOULD NOT BE PLACED IN A BUILT-IN INSTALLATION UNLESS      
  PROPER VENTILATION IS PROVIDED.
7.  NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUC
  THROUGH CABINET SLOTS AS THEY MAY TOUCH DANGEROUS     
  VOLTAGE POINTS OR SHORT OUT PARTS THAT COULD RESULT 

  IN A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF     
  ANY KIND ON THE PRODUCT.
8.  TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT DISASSEMBLE  
  THIS PRODUCT. BUT TAKE IT TO A QUALIFIED SERVICE FACILITY IF
  SERVICE OR REPAIR WORK IS REQUIRED. OPENING OR REMOVING  
  COVERS MAY EXPOSE YOU TO DANGEROUS VOLTAGES OR OTHER  
  RISKS. INCORRECT REASSEMBLY CAN CAUSE ELECTRIC SHOCK      
  WHEN THE APPLIANCE IS SUBSEQUENTLY USED.
9.  UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER
  SERVICING TO QUALIFIED SERVICE PERSONNEL UNDER THE 
  FOLLOWING CONDITIONS:
  -  WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED 
     OR FRAYED.
  -  IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT.
  -  IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER.
  -  IF THE PRODUCT DOES NOT OPERATE NORMALLY BY 
     FOLLOWING THE OPERATING INSTRUCTIONS. ADJUST ONLY      
     THOSE CONTROLS THAT ARE COVERED BY THE OPERATING
     INSTRUCTIONS, AS IMPROPER ADJUSTMENT OF OTHER 
     CONTROLS MAY RESULT IN DAMAGE,AND MAY REQUIRE 
     EXTENSIVE WORK BY A QUALIFIED TECHNICIAN TO RESTORE    
     THE PRODUCT TO NORMAL OPERATION.
  -  IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS      
     BEEN DAMAGED.
  -  IF THE PRODUCT EXHIBIT A DISTINCT CHANGE  
     IN PERFORMANCE.
10.  AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE)
    DURING AN ELECTRICAL STORM. THERE MAY BE A REMOTE RISK  
    OF ELECTRIC SHOCK FROM LIGHTNING.
11.  DO NOT USE THE TELEPHONE TO REPORT A GAS LEAK IN THE
    VICINITY OF THE LEAK.

PLEASE SAVE THESE INSTRUCTIONS

Summary of Contents for AC8105S

Page 1: ... hours without interruption before use To charge the battery place the handset keypad down in the base unit Ensure that the CHARGE LED on the base lights If the LED Does Not Light 1 Ensure that the AC adapter is plugged in 2 Ensure that the AC adapter is plugged into an unswitched electrical outlet 3 Ensure that the handset charging contacts at the bottom of the handset are making good contact wit...

Page 2: ... cradle or press the OFF key on the handset To answer a call using the handset while it is resting on the base 1 Pick up the handset from the base 2 To end the call replace the handset in the base unit cradle or press the ON key on the handset To answer a call using the speakerphone 1 Press the line key The speakerphone will go off hook answering the ringing line 2 Alternatively press the SPKR key...

Page 3: ...R A BATHTUB WASH BOWL KITCHEN SINK OR LAUNDRY TUB IN A WET BASEMENT OR NEAR A SWIMMING POOL 5 DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART STAND OR TABLE THE PRODUCT MAY FALL CAUSING SERIOUS DAMAGE TO THE PRODUCT 6 SLOTS AND OPENINGS IN THE CABINET AND THE BACK OF BOTTOM ARE PROVIDED FOR VENTILATION TO PROTECT IT FROM OVERHEATING THESE OPENINGS MUST NOT BE BLOCKED OR COVERED THE OPENINGS SHOULD N...

Page 4: ...cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or rel...

Reviews: