17
1. Depress EMS mushroom pushbutton and turn the rotary key to “OFF” position.
2. Depress “START” pushbutton and hold it down, then turn the rotary key from
“OFF” to “ON” position simultaneously. At this time, LED will fast flash in red,
yellow, and green color alternately. This indicates that the transmitter is in the
remote setting mode.
3. Press the “UP” pushbutton. At this time, LED will change to flash in yellow
quickly. This indicates that it is performing the Channel Changing function.
4.
When LED changes to flash 4 times in green and goes off, then the Channel
Changing is completed. If LED changes to flash 4 times in red, then the Channel
Changing is failed. You must go back to step 1 and redo the procedure again.
5.
After completing the Channel Changing, turn the rotary key from “ON” to “OFF”
position and follow the correct power on procedure. Then, the controller is ready to
be normally used again.
3-5-2 Remote Pairing
Remote Pairing allows the transmitter to actively search the receiver to be paired on
site.
After confirming the receiver, the data saved in the receiver, including the
functions settings, ID Code, and the Channel setting, will be download to the
transmitter by radio. In this way, the trouble and the risk of climbing to the receiver
can be eliminated. The procedures are as follows.
1. Depress EMS mushroom pushbutton and turn the rotary key to “OFF” position.
2. Depress “START” pushbutton and hold it down, then turn the rotary key from
“OFF” to “ON” position simultaneously. At this time, LED will quickly flash in
red, yellow, and green color alternately. This indicates that the transmitter is in the
remote setting mode.
3. Press the “DOWN” pushbutton. At this time, LED will change to fast flash in
green and red color alternately. This indicates that it is performing the Remote
Pairing function and searching the receivers available on site.
4. When LED changes to flash in green, it means that it has found a receiver ready to
be paired.
5. At this time, you may press the “START” pushbutton to confirm that the receiver
is the one to be paired. The power-on indicator of the receiver that has been
searched will be turned on and the horn will also make a sound at the same time.
6. If the receiver is not the one to be paired, then press “DOWN” pushbutton to skip
it and go back to step 4 to continue the searching process for the next receiver.
7. If the receiver is the one to be paired, then press “UP” pushbutton to continue the
procedure. At this time, LED will change to flash in yellow. It means that the
transmitter is downloading the data from the paired receiver.
8. When LED turns to green, then press “UP” pushbutton to conclude the procedure
above. At this time, LED will change to flash in green 4 times and go off. It means
that the Remote Pairing is completed.
Summary of Contents for F25
Page 1: ......
Page 2: ......
Page 11: ...8 4 2 F25 Receiver s parts Antenna Wiring Diagram Power On Indicator ...
