Telecor VS-600, Manual

Page: 29 / 32

VS-600 Resident Unit Manual C-7
C.5 Installing the Wired Pull Cord Station
The Wired Pull Cord Station is designed for wall mounting onto a standard one-gang electrical
box with 3-9/32" mounting centers. The unit connects to the terminals marked
JSW9 , shown in
the diagram below.
C.6 Enabling Wireless Pendant or Wireless Pull Cord Operation
To enable a Wireless Pendant or Wireless Pull Cord to operate in conjunction with a VS-600
Resident Unit, complete the following steps:
1.
Simultaneously press and hold the Volume Up and Volume Down buttons on the
Resident Unit until you hear a beep.
2.
Verify that the Menu and Activities LEDs are blinking alternately after the beep.
3.
For a Wireless Pendant, press its button. For a Wireless Pull Cord, pull the cord. On
receiving the wireless device signal, the Resident Unit will play a long beep, and the
Fault and Line LEDs will flash once.
4.
When finished enabling devices, press Cancel .
Note: You can assign up to 4 wireless pendants and 4 wireless pull cords to each resident unit, for a
total of 8 devices.