Getting to Know Your
Incoming Ring Tone
You can select one of four different ringing pitches for incoming
calls to your keystation.
To Change the
of Your Keystation:
With the handset on the keystation;
l
the
key
l
Dial 13
l
Press the
key
Hear test tone
l
Continue pressing the *]
3
key until the required tone
is heard
l
Press the [#] key to select
J a n
The
station
returns
to
Idle mode.
Four different ring frequencies are available
16
2
Your Commander
line Failure Monitoring
If an attempt is made to access an outside line that has failed or is
not connected to the system an error tone is heard and the display
shows ‘NOT CONNECTED’.
This line is then taken out of service and cannot be accessed by
0. When the fault has been rectified and the line is
successfully accessed by pressing the [LINE] key, the system will
return the line to service.
HX1224 Only
If a non equipped [LINE] key is pressed the display shows:
Manager Secretary Pairs
When a station (programmed as the ‘manager’ station) selects DND,
all calls to that station
are
automatically forwarded to
associated
‘secretary’ station. The secretary is the only station that can call to
the manager’s station while DND is selected.
While DND is not selected and the ‘manager’ station is busy,
incoming calls will be transferred to the ‘secretary’.
When the manager station is in
mode the [FLASH] key can be
used to signal or “Buzz the secretary station. This is an audible
indication only: no connection is made.
2
Page 17