The device features three flashing LEDs; each LED can be used to configure your settings. To do that, choose the
appropriate LED (see below) ,and then press the switch for 5 seconds until the number starts flashing. Choose the
required number and release it, so that the number you set will be saved.
NOTE:
in the normal charging status, the controller will
divide the charge equally, when battery 1 is fully
charged, more charge current will be diverted to
battery 2, and then automatically return to charging
battery 1 when its voltage is low. When the controller
detects there is only battery 1, all the charging will
go to battery 1 automatically.
CHARGING LED STATUS
Battery type
Mode
LED
Setting
L1
L2
L3
NOTE: only set the
percentage you want
for battery 1, the
controller will
automatically calculate
the rest for battery 2.
Charging frequency
1
2
3
Sealed battery
Gel battery
Flooded battery
Number
shown
Battery type
Charging priority
Number
shown
0
1
2
Charging
frequency PWM
25 Hz (default)
50 Hz
100 Hz
Number
0
1
2
3
4
5
6
7
8
9
Battery 1
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
Battery 2
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
L4
L5
Battery 1 status
Battery 2 status
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
LED blinking. Short circuit, check the PV panel and the battery, and make sure that
connections are correct.
LED slowly flashing. Fully charged.
LED ON. Charging
LED quickly flashing. No charging
LED OFF. No battery or overvoltage.
LED blinking. Short circuit, check the PV panel and the battery, and make sure that
connections are correct.
LED slowly flashing. Fully charged.
LED ON. Charging
LED quickly flashing. No charging
LED OFF. No battery or overvoltage.
