Motor limits and set up
The control panel has to detect the TOP limit before normal operation and each time
after mains power is turned off and then on again.
It is important to set the motor limits first using either a test lead or the two buttons
inside the control panel and the limit adjustment screws.
Using either a test lead or the P1 (down) & P2 (up) hold - to - run buttons inside the control panel:
1.
Run the motor in the down direction until it stops. At this point attach the curtain via the straps
provided unless already attached.
2.
Fine adjust the bottom limit.
3.
Run the motor up to the top leaving only the bottom piece of the door within the tracks.
4.
Fine adjust top limit.
If the door runs higher than needed reduce the travel via the below steps:
To increase the travel turn the limit screw towards the ‘+’ direction.
To reduce the amount the door travels turn the limit to the ’-’ direction.
Tip:
Right hand motor - RED = Down limit - WHITE = Up limit
Left hand motor - WHITE = Down limit - RED = Up limit
P1
P2
To Exit Hold - to - run set up mode press the P1 & P2 buttons
together for 3 times on the 3
rd
press hold until it beeps and
both L1 & L2 lights go out. The panel is now in Day to Day
running mode.
Limit
Adjuster
Limit
Adjuster
Arrows
indicate
Direction
of rotation
for the
tube motor
Hold - to - run set up mode
If the door is moving in the wrong direction:
a. STOP the manoeuvre
b. Switch off the control unit
c.
Swap BLACK & BROWN motor wires over – terminals 5 & 7
d. Power up the board again – go back to bullet point 1
Please ensure you follow each step before moving onto the next page
Summary of Contents for Simple Panel
Page 1: ...Teleco Simple Panel Set up guide Wired safety edge system...
Page 10: ......
