Teleco MAGIC SAT EASY, Installation Manual And User'S Manual

Page: 4 / 32

Important notice
Magic Sat Easy Vers. 003
4
Important notice
Magic Sat Easy is packaged in two separate cartons for transport reasons:
a) the first package contains the driving unit with all the cables, and the control box.
b) the second package only contains the dish.
• It is important to check that the dish has not been damaged during transport when the
package is opened. In particular, check the following well:
• By resting the dish edge against a flat surface (e.g. the floor or a wall) check that it
makes contact to the surface all around. If it is not so, try and make the edge level,
without denting the dish, or call our After-Sales Service.
• After checking that everything is in order, install the dish on the driving unit as follows:
1) Temporarily connect the Control Box to the driving unit through the grey motor
cable.
2) Connect the control board to the Control Box through the RJ45 cable.
3) Power the Control Box using a battery.
4) Press the switch-on button and wait for the dish support mast to rise.
5) Once the desired position has been reached, turn off the Magic Sat Easy via the
same button.
6) Secure the dish to the mast and screw down the four supplied screws.
7) Turn the unit on again and wait for the antenna to close.
8) Disconnect the the Control Box, the battery and install the driving unit on the
vehicle.
YES NO