TELE System
6
3 First time installation
When all the connections on the receiver are ready (section 2.2), the mains lead is plugged in and the rear
mains switch is on position I (ON), the receiver will start up automatically. If this does not happen, press the
ON button on the front panel of the receiver or on the remote control.
An easy installation menu will be displayed where you can set different parameters and then run the channel
scan:
Language
Use the arrow / button to select a language for the On Screen Display menu (OSD). Press to go to
the next parameter.
Region
Use the arrow / buttons to select your Country. Press to proceed.
CAUTION
If the wrong country is selected the channel scan may not detect all the channels available.
Summer Time
Choose the proper summer time option (
Auto
/
On
/
Off
) by using the arrow / button. Press to move
forward.
CAUTION
Under automatic summer time mode, the receiver will follow the time data transmitted by the broadcaster.
Display Mode
Adjust the video resolution of the HDMI output with arrow / button, taking care about the technical
characteristics of the connected TV monitor. Push to go down.
Aspect Mode
With arrow / button set the video aspect ratio between
16:9 FS
(
F
ull
S
creen),
16
:9
PB
(
P
illar
B
ox - black
left and right bars during 4:3 video source),
4:3 FS
(
F
ull
S
creen) e
4:3 LB
(Letter Box - black up and down
bars during 16:9 video source). Press to proceed.
LCN
When the Logical Channel Numbering option is active, after the scanning, the TV/Radio services will be
automatically stored in the list following the order requested by broadcasters. Press to go forward.
NOTE
When
LCN
mode is turned on, we suggest to not change the channel positions in the
TV/Radio Channel List
menu.
Password Definition
Input a 4-digit numeric password (PIN) on
New Password
field for the Parental Control function (see par.
4.2), then reinsert the same password on
Confirm Password
. Press to proceed.
Channel Scan
Press OK item to start the automatic channel scan. When the scan is completed, if there are no LCN conflict
the receiver will enter the viewing mode, otherwise see below step.
LCN Conflict Resolution
When the LCN function is active and more than a service asks for the same channel list position, the system
will recognize that conflict and display on screen a list of the involved services. Choose the preferred channel
by using / arrow buttons e confirm with OK. As an alternative, go to the automatic solution. Also, if the
user doesn’t make a choice, after a few time the appliance will carry out a solution by itself. After these
actions, the receiver will enter the viewing mode.
