Chapter 4: INSTALLERS GUIDE
For digit:
1
2
3
4
5
6
7
8
9
0
TG-TX-MNL8, TG-TX-MNR8,
PRESS BUTTON:
1
2
3
4
5
6
-
-
-
-
TG-TX-MXL12, TG-TX-MXR12,
PRESS BUTTON:
1
2
3
4
5
6
7
8
9
10
4. WITHIN 3 MINUTES FROM PULLING OUT THE STOP BUTTON:
Press a button to select the receiver(s) that you want to operate. The receiver(s) that was selected in the
last session will be automatically selected, which is indicated by the corresponding LED(s) that light red.
If no receiver(s) has been selected, the LEDs for all available receivers will flash red. If a receiver is
selected, the LEDs next to the left and the right start buttons flash red. If no receiver(s) are selected, only
the LED next to the right start button flashes red.
5. Press both start buttons at the same time.The buzzer beeps.
6. Release the start buttons. The buzzer stops beeping. The top LED flashes (green when the battery
capacity is good, red when the battery capacity is poor).
7. When radio communication has been established, the top LED lights (green when the battery
capacity is good, red when the battery capacity is poor).
If radio communication is not established within 25 seconds, the transmitter turns off.
TURN THE TRANSMITTER OFF
1. Press the stop button. The transmitter turns off. All relays deactivate.
-
42
-
Summary of Contents for TG-R9-1
