Teldat VisorALARM PLUS 2U, Operating Instructions Manual

Page: 6 / 24

VisorALARM PLUS 2U System Overview
1 - 4
Doc. DM375-I
Ver. 1.0
echo packets towards this address fail then a code 356 alarm is generated from the Contact-ID protocol
(
Loss of central polling ). Default is 356.
In order to simplify installation and updating of the registered mIP/IPDACTs, the IP VisorALARM
PLUS 2U receiver has additional facilities.
To install new mIP/IPDACTs, the Teldat VisorALARM PLUS 2U holds configuration patterns
associated to installer passwords. These permit you to automatically register new mIP/IPDACTs in
the supported mIP/IPDACT list and at the same time enable the mIP/IPDACT to request the necessary
configuration for start up. The device can simultaneously have multiple patterns; the choice of one or
other depends on the installer password used in the mIP/IPDACT to request the service.
In order to maintain and update the registered mIP/IPDACTs base, the Teldat VisorALARM PLUS
2U has commands available to remotely update one or multiple configuration parameters used by the
mIP/IPDACTs.