Chapter 3 Installing the Router
This chapter describes the steps to successfully install the Regesta Smart PRO router. It contains the following sec-
tions:
•
on page 14
•
Removing/Installing the Connectors Protector
on page 14
•
Installing a DIN rail mount accessory
on page 16
•
on page 17
3.1 Workplace Conditions
Warning
This equipment must be installed in restricted access locations. Only trained and qualified personnel
are allowed to install, replace or service this equipment as instructed in this installation guide.
• The device should not be placed amongst papers, magazines or other elements that could hinder natural air circu-
lation.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
3.2 Removing/Installing the Connectors Protector
The Regesta Smart PRO includes a protective case for connectors. Its main function is to prevent accidental electric-
al discharges, which can prove dangerous. Thanks to the casing, direct contact with connectors is avoided while the
device is operating.
Warning
This unit might have more than one power supply connection. All connections must be removed to de-
energize the unit.
To remove the case that protects the connectors, follow these steps:
In the middle of the front panel you will find a fastening mechanism. To remove the casing, rotate the fastening piece
90º to the right or left.
The following figure shows you how to remove the protective case from the device.
3 Installing the Router
Teldat S.A.
14
Regesta Smart PRO
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in
on page 21 and
on page 21.