Fig. 7:
Connections for the configuration
2.2 Installing the SIM card
The Teldat G1N routers have a Wireless WAN interface that, in order to operate, may require at least one SIM card
that must be inserted into the device.
The Teldat G1N routers have two SIM trays. One is accessible from the outside and the other is located inside the
device.
You must always insert at least one SIM card. When only one SIM card is going to be used in these devices, it can
be inserted into either of the two SIM trays. However you must remember that you will need to suitably configured
the router so it selects the appropriate tray.
Warning
Never install the SIM card when the device is switched on.
Always disconnect the device from the main power supply before inserting the internal SIM.
Always disconnect the device before removing the casing to get to the internal SIM.
When inserting the SIM card, please protect yourself against electrostatic discharges (ESD).
Do not touch the SIM card connectors.
2.2.1 Installing the internal SIM
To access the internal SIM you need to open the upper casing of the device. To do this you need to undo the four
screws which are on the underside of the device. You’ll find the tray just below the WWAN antenna connector and
situated on the device’s main motherboard.
In order to insert a SIM card in the internal tray, locate the retaining flange (metal fastening with OPEN and LOCK on
it) so you can open the tray and place the SIM card on it. The steps are as follows:
(1)
Push the fastening to the right (OPEN) until the tray is released.
(2)
Open the upper part of the tray.
Teldat S.A.
2 Installation
Teldat Router G1N
7
