Default host flash file name
:
Boot delay (0-9 seconds)
: 3
Boot image (0=latest, 1=previous) : 1
Board Id (0-0)
: 96358C1PL
Number of MAC Addresses (1-32)
: 4
Base MAC Address
: 22:22:22:22:22:22
PSI Size (1-64) KBytes
: 24
Main Thread Number [0|1]
: 0
*** Press any key to stop auto run (3 seconds) ***
Auto run second count down: 0
Booting from only image (0xbe8a0000) ...
Code Address: 0x80010000, Entry Address: 0x80330000
Booting version 10.08.00-00.00
Decompression OK!
Entry at 0x80330000
Closing network.
Closing DMA Channels.
Starting program at 0x80330000
CIT release: XXXXX
Current software license: XX XX
S/N: XXX/XXXXX
........
Default configuration used
Parsing text mode configuration ...
Configuration parsed
Initializing
Press any key to get started
This process does not delete the configuration that was previously stored; it simply re-establishes the default config-
uration.
1.4.2 Procedure to force startup in BOOT mode
Carry out this process if you need to force the router to startup in BOOT mode to load/upgrade the C.I.T. image from
BOOT. For further information, please see the manual on software updating (
Dm748-I Software Updating
).
Follow these steps:
• Turn off the device by means of the ON/OFF switch.
• Using a sharp object, press the RST pushbutton and hold it down.
• Turn the device on with the ON/OFF switch.
• Wait until the WLAN LED begins to blink (see Figure 16). Keep the RST pushbutton held down.
Fig. 16: The WLAN LED blinks
• After about 15 seconds, the WLAN LED goes out and the DSL LED lights up (see Figure 17). Keep the pushbutton
held down.
Fig. 17: The WLAN LED goes out and the DSL lights up
• After about 3 seconds, the WLAN LED lights up. This time it’s steady i.e. not blinking (see Figure 18) and the DSL
goes out. Release the reset button at this point.
Teldat S.A.
1 Installing the Router
Teldat Connect-104 Router
11