COMPLETE ERASURE
Of the receiver memory
The memory of the receiver may be totally erased.
Remove the memory from the receiver (see TANGO instructions) and plug it into the SLAVE base of the card provided.
Plug in this card with the memory into the MEMORY CONNECTOR of the programmer.
From the main menu:
4
(Mem) selection of memory mode.
A reminder to plug in the memory on the relative base appears on the display.
P
Confirmation of erasure is requested.
P
Confirmation of operation.
During erasure : CANCELL. MEMORY is shown on the display; at the end of operations : END OF OPERATION is
indicated.
C
Return to main menu.
DUPLICATING RECEIVER MEMORIES
Copies of the receiver memory may be made.
To duplicate the memory of a receiver, use the programmer with the provided card plugged into the MEMORY
CONNECTOR.
This card allows two memories to be housed.
Plug in the empty memory onto the SLAVE base and the full one to be copied onto the MASTER base.
From the main menu:
4
(Mem) selection of memory mode.
A reminder to insert the memories on the relative base appears on the display.
P
Confirmation of duplication is requested.
P
Confirmation of operation.
During duplication : DUPLICATION. MEM. is shown on the display; at the end of operations : END OF OPERATION is
indicated.
C
Return to main menu.
RECHARGEABLE BATTERY
As the TANGO PRG programmer may also be used outdoors, it comes with an internal rechargeable battery. The state
of the battery is shown on the display; when the battery is discharged the symbol appears, recommending use of
the programmer with external power supply.
The moment the external power supply is connected, the discharged battery symbol changes to the recharging
symbol
To reduce battery recharging times, it is advisable to keep the programmer switched off during this stage.
Full recharging usually takes approx. 20 hours.
Upon switching on again, if the battery is charged, no symbol appears on the programmer display.
