READING A CODE
Of a transmitter
The code of any transmitter of the Tango range may be read.
Rest the TANGO transmitter in the shape outlined in the programmer.
From the main menu:
3
(Ric) selection of the code reading mode.
Press the transmitter key the code of which is to be read. Once read, the code is shown on the display.
C
return to the main menu.
If the number 1.048.575 appears, it means that the transmitter has no code stored.
If the writing “Different family” appears, this means that it is impossible to operate with the programmer on that remote
control.
ERASING A CODE
Of a transmitter
The code of a transmitter may be erased.
To erase the code 5678.
From the main menu:
2
(Can) selection of the code erasure mode.
5678
type in the code to be erased.
P
enter into the programming mode.
1
(Tra) select the device for which the code is to be erased (in this case a transmitter).
P
confirm the operation.
The red “Transfer” led on the front panel of the programmer now comes on, showing the start of erasure.
Rest the transmitter in the shape outlined in the TANGO PRG and press a transmitter button until the writing CANC OK
appears for a moment on the display.
Follow the same procedure to erase the code (which may be the same or different) also in the other transmitter buttons.
If the writing CODE ERR appears, this may mean that:
The code to be erased is wrong.
If button 1 is pressed during transmitter programming, the code is automatically erased also in the other buttons.
If button 2 (or 3 or 4) is pressed during programming, the code is only erased in the relative button.
