GW-483S Installation Guide
Rev. B
The information in this document is subject to change without notice and describes only the
product defined in the introduction of this documentation. This document is intended for the use of
Telco Systems' customers only for the purposes of the agreement under which the document is
submitted, and no part of it may be reproduced or transmitted in any form or means without the
prior written permission of Telco Systems. The document has been prepared to be used by
professional and properly trained personnel, and the customer assumes full responsibility when
using it. Telco Systems welcomes customer comments as part of the process of continuous
development and improvement of the documentation.
If the Release Notes that are shipped with your device contain information that conflicts with the
information in the user guide or supplements it, follow the Release Notes.
The information or statements given in this document concerning the suitability, capacity, or
performance of the mentioned hardware or software products cannot be considered binding but
shall be defined in the agreement made between Telco Systems and the customer. However, Telco
Systems has made all reasonable efforts to ensure that the instructions contained in the document
are adequate and free of material errors and omissions. Telco Systems will, if necessary, explain
issues which may not be covered by the document.
Telco Systems' liability for any errors in the document is limited to the documentary correction of
errors. TELCO SYSTEMS WILL NOT BE RESPONSIBLE IN ANY EVENT FOR ERRORS IN
THIS DOCUMENT OR FOR ANY DAMAGES, INCIDENTAL OR CONSEQUENTIAL
(INCLUDING MONETARY LOSSES), that might arise from the use of this document or the
information in it.
This document and the product it describes are considered protected by copyright according to the
applicable laws.
Telco Systems logo is a registered trademark of Telco Systems, a BATM Company.
Other product names mentioned in this document may be trademarks of their respective
companies, and they are mentioned for identification purposes only.
Copyright © Telco Systems 2007. All rights reserved.
Safety Considerations
2