Telair Silent 7300H, Installation And User Manual

Page: 9 / 24

9
GB
Before making any
electrical connections always make sure
the power is disconnected inside the
distribution board and that the wire ends
are not live.
It is compulsory for the air conditioner to be
powered via a separate line protected by a 10
A thermomagnetic switch.
To ensure good
insulation under all possible conditions
electrical
wiring must be properly
sheathed.
4.3 Positioning the air conditioner
Before positioning the air conditioner on the
vehicle roof it is necessary to lay a sufficient
amount of slow-drying sealant around the rim
of the aperture.
Bring the air conditioner onto the roof (fig. 7
ref. 2) and, without scraping it, position it
over the 395 x 395 mm opening previously
lined with sealant. Correct alignment of the
air conditioner on the roof will provide a view
- from inside the camper - of the 4 threaded
fixing seats.
The arrow in fig. 7 indicates direction of
forward drive.
The framed perimeter
support seal must be aligned with the
edge of the hole (fig 7 ref. 1).
Working from inside the vehicle, shift the air
conditioner until the four fixing threads are
aligned with the square 395 x 395 mm
opening of the hole on the roof.
Line the four external sides of the connecting
duct with adhesive insulating tape so that it
adheres to the folded fixing edge (fig. 8).
Working from inside the camper, insert the
connection duct at the base of the air
conditioner; use the four self-tapping screws
L.12 mm (supplied). Align the duct with the
rectangular hole of the ventilator (fig. 9). The
arrow in figure 9 indicates the direction of
forward drive.