Telair Silent 7300H, Installation And User Manual

Page: 10 / 24

10
GB
Fit the air/block tunnel with the supplied
screws (fig. 10
) . It is important to attach the
screws according to a driving torque of
2 Nm, that is, 0.2 kgm.
You are advised to use a torque wrench.
Incorrect tightening can
damage the support base of the air
conditioner, compromise the seal and
cause loud noise inside the vehicle when
the conditioner is in operation.
Cut the two sides of the connector duct (fig.
11) so that they do not protrude from the
tunnel edge.
Fold the two long sides of the connector duct
(fig. 12) so that they are horizontally in
contact with the horizontal surface of the
tunnel.
The resulting connection is shown in Fig.13.
4.4 Connecting the power lead
Connect the 230 Vac power lead to the one
on the just-installed conditioner (fig. 14).
Observe the wire colours:
blue wire: neutral
brown wire: phase
yellow-green wire: earth ( )
Check that the power lead is not
excessively long as it could obstruct the
intake grilles.