www.tekvox.com
TekTouchPad - Podium
78034 Installation Guide
Step 4: Fasten Back Mounting Plate to Wedge
Using the two (2) provided machine screws, attach the back mounting plate to the
angled face of the wedge. Ensure that the “
TOP
” text is facing upwards, and that
the arrows point towards the taller end of the wedge.
Be very careful
not to overtighten these screws
, as this can warp the plate and prevent
the TekTouchPad from seating properly.
Step 5: Route Cable up through Mounting Wedge
Route clear plastic RJ12 head of black DB9/RJ12 Serial Cable from
underneath table surface through 5/8” hole drilled in Step 2. Run cable out
through rectangular opening in mounting wedge, with at least 6” of slack.
Step 6: Connect & Mount TekTouchPad
Connect clear plastic RJ12 head of black DB9/RJ12 serial cable to port
on back of TekTouchPad. Ensure that the head clicks into place.
Orient the TekTouchPad such that the cable runs directly downward,
and the wider portion of the housing is lower. Gently push the
TekTouchPad towards the mounting wedge, ensuring that the cable
does not get pinched, kinked, or bent too sharply.
Align the four posts of the back mounting plate with the four holes on the back of the TekTouchPad
housing. Once aligned, push the TekTouchPad towards the mounting plate until mounted securely.
Check that the TekTouchPad does not move when pressed.
Step 7: Finalize Cabling
1. Plug green 3-pin connector of 3-pin/DB9 serial cable into RS232
port of 1201-N+
2. Connect DB9 head of gray 3-pin/DB9 serial cable to DB9 head of
black DB9/RJ12 serial cable. Tighten screws until snug to lock heads
together for a secure connection.
3. Connect 2.1mm male plug (with central pin) of black DB9/RJ12
cable to 2.1mm female connector of TekTouchPad power supply.
4. Connect TekTouchPad power supply to available standard
electrical outlet.
Ensure that all cables are neatly routed, and that any excess length is
neatly coiled without obstructing access to any equipment.
