Tektronix WFM90D, Quick Start Manual

Page: 47 / 170

Using the Menus
WFM90D and WFM91D Service Manual
2- 17
Operating Menus
The following pages describe the operating menus, shown in Figure 2--9 and
Figure 2--10.
Each operating mode has an associated menu. In addition, the Waveform, Vector,
Picture, and WIP operating modes have an associated digital menu.
Operating menu selections affect only the display mode in which they appear
(unless otherwise noted). If you switch to a different operating mode, the menu
for the new mode will display.
To enter an operating menu, select the desired operating mode (such as Wave-
form or Audio), and then press the MENU button.
To exit, press the MENU button again.
To enter a digital operating menu, first ensure that the input control is configured
for AUTO or DIGITAL (see
Configuration Menu on page 2--21). Then select the
desired operating mode (Waveform, Vector, Picture, or WIP) and hold the
MENU button for 2 seconds.
To exit, press the MENU button again.
Press the bezel button that corresponds to the desired selection on the display.
When you make a selection, changes are displayed immediately.
To adjust values, press the two right bezel buttons while displaying a menu
selection such as
B
TRACE ADJUST
Y
.
Press the WFM button and the MENU button to open the Waveform operating
menu. Hold the MENU button in for two seconds to open the digital menu. For
more details on menu access, see page 2--17.
Waveform menu choices are shown in Table 2--2. The Waveform menu tree is
shown in Figure 2--9.
Accessing Menus
Accessing Digital Menus
Using the Menus
Waveform Menu