Installation Instructions
Installation Instructions
This section contains all procedures needed to rackmount the instrument.
CAUTION.
This kit requires you to remove the right-side panel of the instrument
rack you intend to use. You must have access to the right side of your instrument
to connect the logic analyzer probes when the instrument is installed in the rack.
Minimum Tool and Equipment List
The following tools are required to attach the rack-adapter kit hardware, install
cabling hardware, and mount the rack-adapted instrument into a standard
equipment cabinet. All tools are standard tools that are readily available.
Table 2: Tools required for rackmount installation
Item no.
Name
Description
1
Screwdriver handle
(magnetic)
Accepts 1/4-inch hexagonal
head driver tips
2
No. 2 Phillips or Pozidriv tip
Phillips or Pozidriv-driver
tip for number 2 size screw
heads
3
T-15 Torx tip
Torx-driver tip for T-15 size
screw heads
4
11/32-inch wrench
Wrench or nut driver can be
used to install slides
5
Torque driver
Accepts 1/4-inch hexagonal
head driver tips
These instructions are for personnel who are familiar with servicing the product.
If you need further details for disassembling or reassembling the product, refer to
the appropriate product manual. Contact your nearest Tektronix Service Center or
Tektronix Factory Service for installation assistance.
WARNING.
To prevent the rackmounted instrument from tipping forward onto the
operator, install the instrument so that the operator is able to access all of its
rear-panel connectors without pushing down on the instrument.
Verify that the rack does not become unstable with the instrument fully extended.
Do not leave the instrument extended when
fi
nished accessing the rear panel.
TLA6200, TLA6400, & TLA7012 Rackmount Kit Instructions
9
Summary of Contents for TLA6202
Page 2: ......
