General Safety Summary
General Safety Summary
Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it.
To avoid potential hazards, use this product only as speci
fi
ed.
Only quali
fi
ed personnel should perform service procedures.
While using this product, you may need to access other parts of a larger system. Read the safety sections of the other
component manuals for warnings and cautions related to operating the system.
To Avoid Fire or Personal Injury
Use Proper Power Cord.
Use only the power cord speci
fi
ed for this product and certi
fi
ed for the country of use.
Connect and Disconnect Properly.
Do not connect or disconnect probes or test leads while they are connected
to a voltage source.
Ground the Product.
This product is grounded through the grounding conductor of the power cord. To avoid electric
shock, the grounding conductor must be connected to earth ground. Before making connections to the input or output
terminals of the product, ensure that the product is properly grounded.
Observe All Terminal Ratings.
To avoid
fi
re or shock hazard, observe all ratings and markings on the product. Consult
the product manual for further ratings information before making connections to the product.
The inputs are not rated for connection to mains or Category II, III, or IV circuits.
Connect the probe reference lead to earth ground only.
Power Disconnect.
The power cord disconnects the product from the power source. Do not block the power cord; it
must remain accessible to the user at all times.
Do Not Operate Without Covers.
Do not operate this product with covers or panels removed.
Do Not Operate With Suspected Failures.
If you suspect that there is damage to this product, have it inspected by
quali
fi
ed service personnel.
Avoid Exposed Circuitry.
Do not touch exposed connections and components when power is present.
Use Proper Fuse.
Use only the fuse type and rating speci
fi
ed for this product.
Wear Eye Protection.
Wear eye protection if exposure to high-intensity rays or laser radiation exists.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
Provide Proper Ventilation.
Refer to the manual’s installation instructions for details on installing the product so it has
proper ventilation.
TDS6000B & TDS6000C Series Quick Start User Manual
iii