TD140 Hardware Maintenance Guide 7.13.2
35
4
TD140 Maintenance Guidelines
Rev. 001-140228
Remove the PPM40 RTM
Some RTMs have two locking ejector latches, and others have one locking ejector latch and
one friction latch. It is important that the lock is released before opening a locking ejector
latch. See
for an illustration of the ejector latches.
Figure 4.4 - Opening Ejector Latches
Perform the following steps:
1.
Release the two retaining screws.
2.
If one of the latches is a friction type, carefully pull the latch handle away from
the RTM to open the latch. To open a locking ejector latch, disengage the lock
by sliding the lock toward the handle to release the catch from the shelf latch
rail, then pull the handle away from the RTM. See
3.
Remove the RTM from the shelf.
Slide lock toward
handle to release lock,
then pull handle out
Pull handle out
Friction latch
Locking latch
Tektronix Communications | For Licensed Users | Unauthorized Duplication and Distribution Prohibited
