Controls
ON/OFF
•
Power switch (LED red when on )
ROW / COLUMN
(Signal Selectors)
•
Selects desired signal
•
Signal output at RF Output starts ~2 s after selection,
or when Signal LED stops blinking
INT/EXT
– select between
•
INT: internal signal / modulation (LED on)
•
EXT: use EXTERNAL I/Q modulation inputs (LED on)
•
OFF: no output (LED on)
RUN MODE
•
FREERUN – waveforms continuously output (LED on)
•
SINGLE – single instance / pulse output (LED on),
press TRIGGER to generate
TRIGGER
•
Generates single waveform instance
(selected waveform) at RF OUT (LED blinking
when required)
Inputs/Outputs
USB
•
Connect supplied USB “Y” cable to two USB 1.0/2.x ports
EXTERNAL I / Q
INPUT
•
Selected via
INT/EXT
button
•
DC – 5 MHz, 50 ohm inputs, 1 V p-p (+4 dBm) max
BASEBAND I / Q
OUTPUT
•
DC – 5 MHz, 50 ohms, ±100 mV into 50 ohms
RF (output)
•
Connect to analyzer input (50 ohms)
28V in / Noise Out
– for use with RSA5k/6k Option 14
(Noise Figure measurement)
•
Connect BNC to RSA5k/6k rear panel 28 V output
•
Connect NOISE OUT to DUT, then to RSA5k/6k RF IN
(Refer to RSA5k/6k documentation for 28 V output setup.)
USB Power
On/Off
Noise Out
28 V in required
I and Q
Input
RF Output
Baseband
Q Output
Baseband
I Output
Signal
Selectors
Signals
Trigger Run
Mode
Internal
External
See the RSA Demo User manual (077-1038-xx) for additional information. Available at www.tektronix.com/manuals.