Tektronix RSA3303B, User Manual

Page: 21 / 79

Installation
Figure 7: Spectrum of the RSA3408B calibration signal (100 MHz, about -20 dBm)
3. Check the center frequency and peak amplitude using the marker:
a. Press the PEAK key on the front panel to place the marker on the peak.
(See Figure 7.)
b. Check the marker readouts on screen. The frequency should be 100 MHz
(RSA3408B) or 50 MHz (RSA3300B) and the amplitude should be
approximately -20 dBm.
c. Press the MARKER SETUP key on the front panel and then the Markers
side key to select Off. Check that the marker disappears.
4. Check the RBW (Resolution Bandwidth) while changing the span setting.
a. Press the SPAN key on the front panel.
b. Con fi rm that the span is 36 MHz (RSA3408B) or 15 MHz (RSA3300B)
and the RBW is 100 kHz (RSA3408B) or 80 kHz (RSA3300B) in the
setup display on the upper part of the screen. (See Figure 8.)
RSA3303B, RSA3308B, and RSA3408B User Manual 9