Tektronix P6248, Service Manual

Page: 51 / 58

P6248 1.7 GHz Differential Probe Service Manual
39
Appendix A: Alternate Verification Procedures
This appendix contains alternate procedures for verifying the common mode
rejection ratio specifications.
Use these alternate procedures only if it is not feasible to obtain a network
analyzer.
For the complete set of performance verification procedures, refer to the
Performance Verification section on page 5 and refer to this section when
directed to do so.
Equipment Required
Table 8 lists the equipment required to perform the procedures in this section.
The types and quantities of connectors may vary depending on the specific
equipment you use.
Table 8: Test equipment
Description Minimum requirements Example product
Sine wave generator (pre-
ferably a synthesizer) 0 dBm to 20 dBm from 1 MHz to
1.5 GHz. Fluke 6066
Spectrum analyzer 1 MHz to 1.8 GHz (dynamic range
≥
100 dBm at 1 MHz)
Advantest R3365A
TEKPROBE Power Supply Tektronix Type 1103 Tektronix Type 1103
BNC-to-Type-N coax adapt-
ers (2) Type N-male-to-BNC female 103-0045-00
BNC cables (2) 50
Ω
, 18 inch 012-0076-00
Probe tip adapters
BNC-to-probe tip
(included in the standard probe tip
accessory kit) 020-2203-00