Tektronix P6248, Service Manual

Page: 18 / 58

Performance Verification
6
P6248 1.7 GHz Differential Probe Service Manual
Table 5: Test equipment (cont.)
Description Example product Minimum requirements
Oscilloscope with sampling
head Tektronix 11800 series
oscilloscope with SD-24
TEKPROBE Power Supply Tektronix Type 1103 Tektronix Type 1103
BNC cables (2) 50
Ω
, 42 inch 012-0057-01
SMA cables (2) 50
Ω
015-0562-00
Banana-to-banana patch
cords (3) 2 red
1 black
012-0031-00
012-0039-00
Adapter (3) Dual-male-banana-to-female BNC 103-0090-00
Adapter (2) BNC male to dual binding post 103-0035-00
0.025” square pins (3) Approximately 0.75 inch long,
smooth, gold plated. 131-1614-00
Precision inline BNC
terminator 50
Ω ±
0.1% 011-0129-00
Probe tip adapters
Y-lead
BNC to probe tip
probe ground lead
(included in the standard probe tip
accessory kit) 020-2328-XX
Adapter SMA Male-to-male 015-1011-00
Adapter (2) SMA Female-to-BNC male 015-0572-00
Preparation
Prepare the equipment as follows:
1. Connect the Y-lead adapter to the inputs of the probe and the ground lead to
the probe ground. (For a description of these accessories, refer to the list of
standard accessories on pages 33 and 34.)
2.
Attach the probe to the 1103 TekProbe power supply.
3.
If necessary, set the line selector of the 1103 power supply to the correct
voltage.
4. Turn on the 1103 power supply.
5.
Set the 1103 offset to off (button not illuminated).
6. Allow the probe and test equipment to warm up for 20 minutes at an ambient
temperature of 20
_
C to 30
_
C (68
_
F to 86
_
F).
Perform the verification procedures in order.