Tektronix MSO54, Programmer'S Manual

Page: 898 / 1026

Commands listed in alphabetical order
TRIGger:B:RESET:TYPe
This command sets or queries the type of A → B sequential trigger reset. If the B
trigger reset is active, the reset criteria are part of the B triggering sequence. If
the reset conditions de
fi ned by the reset type are met, the instrument must start
over searching for a new occurrence of the A event.
You must identify a trigger Source and Threshold for each reset type, except
for the Timeout trigger type.
NOTE. If a reset condition occurs, the reset criteria itself is reset and must start
over.
Group
Trigger
Syntax
TRIGger:B:RESET:TYPe {NONe|TIMEOut|EDGE}
TRIGger:B:RESET:TYPe?
Arguments
NONe
defeats the trigger reset feature.
TIMEOut
initiates a reset if the timeout conditions speci fi ed by
TRIGger:B:RESET:TIMEOut are met.
EDGE
initiates a reset if the edge trigger conditions are met.
Examples
TRIGGER:B:RESET:TYPE NONE
deactivates the sequential trigger reset.
TRIGGER:B:RESET:TYPE?
This query might return
:TRIGGER:B:RESET:TYPe
TIMEOUT
, indicating that the sequential trigger reset is active following a timeout.
TRIGger:B:STATE
This command sets or queries the state of B trigger activity. If the B trigger state
is on, the B trigger is part of the triggering sequence. If the B trigger state is off,
then only the A trigger causes the trigger event.
Group Trigger
Syntax
TRIGger:B:STATE {ON|OFF|<NR1>}
TRIGger:B:STATE?
Related Commands TRIGger:A:MODe
2-882 MSO54, MSO56, MSO58, MSO58LP Programmer