Tektronix MSO54, Programmer'S Manual

Page: 606 / 1026

Commands listed in alphabetical order
POWer:POWer<x>:SWITCHINGLOSS:RDSOn
This command sets or queries the RDS(on) value for switching loss measurement
in the speci
fi ed power measurement badge. The power measurement badge
is speci fi ed by x.
Conditions Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group Power
Syntax
POWer:POWer<x>:SWITCHINGLOSS:RDSOn
<NR1>
POWer:POWer<x>:SWITCHINGLOSS:RDSOn?
Related Commands POWer:POWer<x>:SWITCHINGLOSS:DEVICEType
Arguments
<NR1>
ranges from 0 to 100
Examples
POWer:POWer1:SWITCHINGLOSS:RDSOn 2
sets the switching loss RDSOn
value as 2 for switching loss measurement of the power measurement badge
Power 1.
POWer:POWer<x>:SWITCHINGLOSS:SWLCONFIGType
This command sets or queries the con fi guration type for the switching loss
measurement in the speci fi ed power measurement badge. The power measurement
badge is speci fi ed by x.
Conditions Requires option 5-PWR, SUP5-PWR, or 5-PS2.
Group Power
Syntax
POWer:POWer<x>:SWITCHINGLOSS:SWLCONFIGType
{SMPS | PFC |
FLYBACK}
POWer:POWer<x>:SWITCHINGLOSS:SWLCONFIGType?
Arguments
SMPS
: Select this option in case of signals without noise and ringing. The V
g
source is not required. Select V
g
souce (Source 3), in case of noisy signal.
PFC
: Select this option when input DUT signals are from Power Factor Correction
Circuit. For this case, V
g
source is mandatory.
2-590 MSO54, MSO56, MSO58, MSO58LP Programmer