2470 High Voltage SourceMeter Instrument Reference Manual
Section 12: SCPI command reference
2470-901-01 Rev. A /
May
2019
12-101
:STATus:QUEStionable:ENABle
This command sets or reads the contents of the questionable event enable register of the status model.
Type
Affected by
Where saved
Default value
Command and query
STATus:PRESet
Not applicable
0
Usage
:STATus:QUEStionable:ENABle <n>
:STATus:QUEStionable:ENABle?
<n>
The value of the register (0 to 65535)
Details
This command sets or reads the contents of the Enable register of the Questionable Event Register.
When one of these bits is set, when the corresponding bit in the Questionable Event Register or
Questionable Condition Register is set, the MSB and QSM bits in the Status Byte Register are set.
For detail on interpreting the value of a register, see
(on page B-15).
Example
:STAT:QUES:ENAB 8
:STAT:QUES:ENAB?
Enable bit 4, Limit 3 Fail, when the limit test 3 failure value is
exceeded. Check to see that the value was set.
Also see
(on page B-6)
:STATus:QUEStionable:MAP
This command queries mapped event numbers or maps event numbers to bits in the event registers.
Type
Affected by
Where saved
Default value
Command and query
Not applicable
Not applicable
0
Usage
:STATus:QUEStionable:MAP <bitNumber>, <setEvent>
:STATus:QUEStionable:MAP <bitNumber>, <setEvent>, <clearEvent>
:STATus:QUEStionable:MAP? <bitNumber>
<bitNumber>
The bit number that is mapped to an event (
0
to
14
)
<setEvent>
The number of the event that sets the bits in the condition and event registers; 0 if no
mapping
<clearEvent>
The number of the event that clears the bit in the condition register; 0 if no mapping
