Section 5: Grading and binning resistors
Model DMM7510 7½ Digit Multimeter Application Manual
5-6
DMM7510-904-01 Rev. D March 2021
Using TSP commands
The following TSP code is designed to be run from Keithley Instruments Test Script Builder (TSB).
TSB is a software tool that is available from
. You can install and use TSB to write
code and develop scripts for TSP-enabled instruments. Information about how to use TSB is in the
online help for TSB and in the “Introduction to TSP operation” section of the
Model DMM7510
Reference Manual
.
To use other programming environments, you may need to make changes to the example TSP code.
By default, the DMM7510 uses the SCPI command set. You must select the TSP command set
before sending TSP commands to the instrument.
To enable TSP commands:
1. Press the
MENU
key.
2. Under System, select
Settings
.
3. Set the Command Set to
TSP
.
4. At the prompt to reboot, select
Yes
.
This sequence of TSP commands grades resistors into established bins of accuracy. After the code
executes, the data is displayed in the Instrument Console of Test Script Builder.
