Models 2450-EC, 2460-EC, and 2461-EC Potentiostats And Galvanostats User's Manual
Section 1: Introduction
077110402/November 2016
1-3
Configure the SMU Instrument for TSP
®
scripts
Make sure to select the TSP command set on your SourceMeter Instrument before running test
scripts on your instrument. You only need to select the TSP command set once.
To select the TSP command set:
1. Press the
MENU
key.
2. Under System, select
Settings
.
3. Select
Command Set
.
4. Choose
TSP
.
5. At the prompt to reboot, select
Yes
.
Select the high-impedance, output-off state
Before making physical connections from the instrument to the test cell, set the output of the
instrument to the high-impedance, output-off state. When the high-impedance output-off state is
selected, the output relay opens, disconnecting the instrument from the load.
To set the output of your SMU to the high-impedance, output-off state:
1. Press the
MENU
key.
2. Under Source, select
Settings
.
3. Select
Output Off
.
4. Choose
High Z
(high impedance).
You may receive a notification about making measurements with the output turned off. Select
OK
to
clear the message, or select
Details
to see more information.
