Command Groups
Table 2-12: Source commands (cont.)
Command
Description
Set or query the current channel as enabled or disabled.
[SOURce]:CHANnel:OUTPut:[STATe]
Set or query the output status of the current channel.
Sets voltage and current level and switch channels at the same
time.
[SOURce:]OUTPut:PARallel[:STATe]
Sets the parallel state of CH1 and CH2.
Sets the serial state of CH1 and CH2.
Sets the power supply to power up with its output turned off, or to
return the output to the state it was in when it powered down.
Channel Combination Commands
These commands allow you to set various channel combinations. The commands
you can use depends on the number of channels your instrument has.
Table 2-13: Channel combination commands
Command
Description
Switch or query the current channel.
Set CH1 and CH2 in series.
Set CH1 and CH2 in parallel.
Set CH1 and CH2 to track.
Remove the combination of channels.
Query which channels are combined.
Display Commands
Display commands are used to clear of show particular strings on the instrument
display.
Table 2-14: Display commands
Header
Description
Set or query the display state.
Set or query the display to show a particular string.
Set to clear the characters on the display and returns the display
to normal mode.
2-12
Series 2200 Programmable Multichannel DC Power Supplies Programmer Manual
Summary of Contents for KEITHLEY 2200 Series
