2-17
Installation
Model 4000-3 Redundant Control Panel Power Supply
To install the redundant Control Panel power supply in a Model 4000-3 control
panel proceed as follows:
1.
Open the lower Control Panel tub and turn the AC power switch on the front
of the primary supply to the OFF (Ø) position.
CAUTION
At the rear of the lower Control Panel, disconnect the power cord from the primary
supply ac source.
2.
Remove the blank plate in the redundant power supply positions illustrated in
0347-04-15
Primary Power Supply
ON/OFF Switch
Blank Plate
Connecter J12
Distribution Board
(068986)
Figure 2-11. Model 4000-3 Redundant Control Panel Power Supply Installation
Summary of Contents for Grass Valley 4000
