Command Descriptions
STATus:DREGister0? (Query Only)
This query reads out the contents of the Device Event Register. Reading the
Device Event Register clears the register.
Group
Status
Syntax
STATus:DREGister0?
Returns
<Decimal data> = the sum (between 0 and 30) of all bits that are true. See the
following table.
Bit number
Weight
Condition
2
4
Last measurement below
low limit.
1
2
Last measurement above
high limit.
STATus:DREGister0:ENABle
This command sets the enable bit of the Device Register 0.
Group
Status
Syntax
STATus:DREGister0:ENABle <bit mask>
STATus:DREGister0:ENABle?
Arguments
<Decimal data> = the sum (between 0 and 6) of all bits that are true. See the
following table.
Bit number
Weight
Condition
2
4
Enable monitoring of low
limit
1
2
Enable monitoring of high
limit
Returns
<bit mask>
FCA3000, FCA3100, MCA3000 Series Programmer Manual
2-101
Summary of Contents for FCA3000 Series
