Performance Veri
fi
cation
3.
Push the front-panel Trigger
Menu
button.
4.
Push the lower-bezel
Coupling
button, and then push the
Noise Reject (DC
Low Sensitivity)
side-bezel button.
5.
Push the
Menu Off
button 2 times, so you can see the screen.
6.
Push the front-panel Trigger
Menu
button.
7.
Push the lower-bezel
Source
button and use Multipurpose knob
a
to select the
channel being tested as the trigger source.
8.
Push the channel button (1, 2, 3, or 4) for the channel that you want to check.
9.
Push the lower-bezel
Probe Setup
button, and then push the
Set to 1 X
side-bezel button.
10.
Push the front-panel
Measure
button, and then push the bottom-bezel
Add
Measurement
button.
11.
Use Multipurpose knob
a
to select the
Peak-to-peak
measurement, and then
push the
OK Add Measurement
side-bezel button.
12.
Push the
Menu Off
button 2 times, so you can see the screen.
13.
Turn the Vertical
Scale
knob to set the vertical scale to 500 mV/div.
14.
Turn the Horizontal
Scale
knob to 400
μ
s/div.
15.
Set the leveled sine wave generator frequency to
1 kHz
.
16.
Set the leveled sine wave generator output level so the peak-to-peak
measurement is between
2.98 V
and
3.02 V
.
17.
Set the leveled sine wave generator to the frequency shown for the
oscilloscope model:
Model
Frequency
DPO2024, MSO2024
200 MHz
DPO2012, DPO2014, MSO2012, MSO2014
100 MHz
18.
Use the Horizontal
Scale
knob to set the oscilloscope to
10 ns/div
.
19.
Check that the peak-to-peak measurement is
≥
2.12 V
. Enter this measurement
in the test record.
20.
Move the input cable to the next channel to be tested.
21.
Repeat steps 6 through 20 for each remaining channel.
22
DPO2000 and MSO2000 Series Speci
fi
cations and Performance Veri
fi
cation