Step By Step Guide (See 4a - 4e)
Place the bike in a stand. Position lever so that it sits parallel to the ground. (See 4a)
Remove disc brake pads to avoid contamination during the bleed procedure. -Insert a disc brake piston setting tool or other non-sharp tool and
push the pistons back into the caliper.
Insert Tektro bleed block into caliper. Bleed block ensures that pistons will not move inward during bleed procedure.
Using a T15 Torx, unscrew the bolt located at the caliper bleed port. (See 4b)
Attach a section of plastic tubing with knurled silver bleed fitting to your syringe (supplied with bleed kit). Fill Syringe halfway with Tektro Mineral Oil.
Hold the Syringe vertically with the tip up and tap out any air bubbles. Install the knurled silver bleed fitting (supplied with the bleed kit) into the
caliper bleed port.
Using a T15 Torx, remove the Reser/oir bleed plug. Set aside.
Install the knurled silver bleed fitting (supplied with the bleed kit) into the reservoir bleed port. Firmly attach a long plastic tube over the bleed fitting,
placing the other end into a clean, dry empty bottle or plastic bag .(See 4c)
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
45
