BLE Asset Tracker User Guide
T0005946_UG
Version 1.1
TEKTELIC Communications Inc.
Confidential
Page 13 of 21
2.4
Commissioning and Activation
The Tracker is shipped in a secured enclosure with the battery preinstalled but disengaged by a
pull tab.
The Tracker enclosure does not need to be opened for activation. Assuming that the Tracker has
been commissioned on the NS, pull out the battery tab to engage the battery. The Tracker will
automatically begin the join process. To turn off the device the battery must be removed. To
reset the device, the external reset button can be pushed; see Section 3.4 for a description of the
reset function.
Refer to Section 3.3 for the expected LED behaviour of the Tracker during the join process. It may
take up to 10 seconds between the time the Tracker was reset and the beginning of the LED join
attempt pattern.
Removing and reinserting the battery will reset the Tracker. As soon as new batteries are
inserted, the Tracker boots up and tries to join a LoRaWAN.
2.5
Mounting
There is a mounting hole on each corner on the bottom side of the Tracker enclosure (see
).
Figure 2-1: The Mounting Hole Locations on the Bottom of the Tracker.
These mounting holes can be used to fasten the enclosure to a solid surface, cable, etc. The
mounting holes are slots so the device can be secured with ropes, zip ties, or hooks depending
on the user’s needs. If using cables or zip ties, they can be thread
ed through both slots on either
side of the enclosure as shown in
. The recommended zip tie width is 3 mm. Mounting
fasteners are not provided with the Tracker.
