CONNECTIONS
CONNECTIONS
P5V30-B4 User’s Manual
P5V30-B4 User’s Manual
15
15
Keyboard Connector
This connection is for a standard IBM-compatible keyboard. May also be known as a 101
enhanced keyboard.
PS/2 Mouse Connector
If you are using a PS/2 mouse, you must purchase the
optional connector bracket. This bracket mounts in one of
the slots in the back of the case, and features a circular
external connector for the PS/2 mouse, plus a 6-pin ribbon
cable that connects to the PS/2 mouse connector on the mainboard.
Floppy drives
The on-board floppy controller supports (2) floppy disk drives with the floppy ribbon cable
provided. Make sure the RED stripe on the ribbon cable is oriented towards Pin-1. Notice
the “twist” between the sets of connectors on the floppy cable. The floppy drive “A”
position is at the END of the cable, whereas floppy drive “B” is hooked to one of the
connectors on the other side of the twist. The cable provides both “Edge” and “Pin”
connectors for both the A and B positions to match the connector on your floppy drives.
IDE Hard Drives and CD-ROMs
The on-board Enhanced IDE controller can support up to (4) IDE hard drives or other
ATAPI devices, such as CD-ROMs. This controller, as with all Enhanced IDE controllers,
consists of both
Primary
and
Secondary
ports. Each port has an associated connector and
cable which can support up to (2) ATAPI devices each.
All IDE devices have jumpers which allow the user to configure the device as either
“Master” or “Slave”. A Master device is one that is ALONE on the IDE cable, whereas a
Slave device is installed as a SECOND device on the same cable. Keep in mind that the
Master device will appear
before
the Slave device in the CMOS Setup, as well as the
Operating System software. *
Refer to the device documentation for jumper settings.
The Secondary IDE port can be used for up to (2) additional ATAPI devices. Normally it’s
recommended that you connect your first hard drive to the Primary port, and the first CD-
ROM to the Secondary.
Make sure to align the RED stripe on the ribbon cable with Pin-1 on the mainboard IDE
connector. On most hard drives and CD-ROMs, the RED stripe should be oriented towards
the power connector of the device.
