Tekram Technology P5T30-A4, User Manual

Page: 34 / 42

MAINBOARD BIOS SETUP MAINBOARD BIOS SETUP
P5T30-A4 User’s Manual P5T30-A4 User’s Manual
32 32
PNP OS Installed - Set to Yes if your operating system supports Plug & Play, such as
Windows

95.
Resources Controlled By - The Award Plug and Play BIOS has the capacity to
automatically configure all of the boot and Plug and Play compatible devices. This
capability is specifically designed for a Plug and Play operating system such as Windows

95. Choices are Auto and Manual (default).
Reset Configuration Data - When set to Enabled, ESCD (Extended System Configuration
Data) is cleared. This setting will automatically be set back to Disabled when the system
reboots.
Enabled and Disabled (default).
IRQ3/4/5/7/9/10/11/12/14/15, DMA0/1/3/5/6/7 assigned to - By default, all resources are
assigned to the PCI Bus except IRQs 3, 4, 14 and 15. If an ISA card requires a particular
IRQ or DMA channel, those resources should be set to Legacy ISA so that the PCI Bus will
not try to use them. Choices are
Legacy ISA and PCI/ISA PnP .
PCI IDE 2nd Channel - Enables or disables (default) the secondary channel of the add-on
PCI IDE controller.
PCI IDE IRQ Map To - Configures what type of IDE disk controller is in use. By default,
Setup assumes that you are using the on-board PCI IDE Controller and this option is set to
PCI-AUTO . If you have equipped your system with an add-on PCI controller, changing this
setting allows you to specify which slot has the controller and which PCI interrupt (A, B, C
or D) is associated with the Primary and/or Secondary port. Most add-on IDE controllers are
configured to use INT# A for the primary and INT# B for the secondary.
SYMBIOS SCSI BIOS - When set to Auto (Default), the system will automatically sense
the presence of any SCSI adapter that uses a Symbios SYM53C8XX SCSI chip:
If the SCSI adapter installed has its own
BIOS on board:
The on-board SCSI BIOS will not be loaded.
The adapter’s own SCSI BIOS will be used.
If the SCSI adapter installed doesn’t have
its own BIOS and the card uses or is
compatible with the SYM53C8XX chip:
The on-board SCSI BIOS will load and
control the SCSI adapter.
*Disabling , the onboard SCSI BIOS prevents it from being active in any way.
PCI Latency Timer - This option sets latency of all PCI devices on the PCI bus. The
settings are in units equal to PCI clocks. Available settings are 0 ~ 248. The default is 80.
Assign IRQ for USB - The Enabled option allows the BIOS to auto-route an IRQ for use by
the USB port.
Used MEM base address - This item allows you to determine which base addresses are not
to be occupied by PCI Card and leave these addresses for some special ISA Card used only.
Choices are C800, CC00, D000, D400, D800, DC00.