02
step
CONNECT AND CONFIGURE DUOS uTEMP WIRELESS TRANSMITTER
DUOS UTEMP WIRELESS TRANSMITTER
INSTALLATION GUIDE
17
09
Click on the
Configuration Mode
( ) button to exit setup and start the equipment in normal operation mode.
After this procedure:
• The
Transmitter
awaits connection to the
Gateway
, when only the red LED flashes;
LED flashes slowly
• The
Transmitter
is connected via wireless and its data is available in the
Gateway
, when the red and green
LEDs flash.
LED flashes
NOTE:
If the green LED does not flash, communication has not been established. Make sure that the devices are at a distance
of at least 3 meters, or remove the antenna from the gateway (in case both devices are near each other).
The
Transmitter LEDs
remain active during 1 minute. After this period, all LEDs shut down in order to optimise battery life.
To reset the transmitter, the batteries should be removed, during - at least - 50 seconds (in sleep mode) or instead, as
the transmitter has a magnetic switch, a magnet can be used to reset it by passing the magnet close to the transmitter’s
front side in the blue LED’s area.
