Rev
.
9-v3_7_en
3
Step-4
а
Installation on the wall
(NO BRACKET)
Step-4b
Installation in the corner
(WITH BRACKET)
Step-5
а
Make marking on the wall
at
the
required
height
applying
the
base
to
installation surface.
Detector base should be
positioned strictly as per
figure of the step 4a
Step-5b
Mount and fix the
bracket at a required height
Step-6
а
Lead wires from power
supply
source
and
signaling zones through
wire insertion hole on the
base.
Attach the base to the
wall
Step-6b
Mount the base
on the bracket by inserting
bracket latches into the de-
tector base slot.
Detector base should be
positioned strictly as per
figure of the step 4a.
Lead
wires
from
power
supply source and signaling
zones through wire insertion
hole on the base
Step-7
Depending on a selected
PCB position, set the ec-
centric knob up or down
by rotating the eccentric
around its axis
Step-8
Replace PCB on its
place, superposing PCB
hole with the eccentric
knob
Step-9
Connect wires to detector
terminals
Step-10
Using sealing material of distribution kit seal
hermetically wire insertion hole and other holes to protect
detector from air and insects ingress
Step-11
Remove jumper from the
Mem
plug.
Install jumpers on
Sens
and
Ind
plugs
Step-12
Turn the detector ON; the indicator blinks
once
per 1 s
for no longer than 60 s
– it means the detector is be-
ing switched to the operating mode
Step-13
During starting of detector operating
mode remove for a short period of
time (2-3s) and install back jumper of
Ind
plug
(
TEST-pass
mode switches
on for 8min)
Step-14
Install detector cover on its
place (until the click)
Step-15
To detect sensitive zones carry
out
TEST-pass
in the secured
zone with the speed of
0,3
m/s.
On detection (indicator is lighted
for 2s) one should stop, mark this
position, then make step back and
continue moving.
Repeat
TEST-pass
in the opposite direction.
Sensitive areas formed by lens will be in the middle of the
marked positions.
Step-16
Push out cover lock from base
slot.
Remove cover
Press out
blanks of
selected
mounting
holes
Press out
blank of
bracket
mounting slot
Mounting
holes
Bracket
latches
b
c
