Teknoware TKT68C, Installation And Maintenance Instructions Manual

Page: 24 / 64

VOT45; Rev 1.1; EN; 10.12.2014
TKT68C
– Installation and maintenance
24
The circuit fuses F1-F24 are located at connectors X1-X3. The central battery unit outputs can be
connected as maintained or non-maintained, using the "Mode" wire links in the following way:
“Mode” link closed
Maintained emergency luminaire circuit (exit luminaire)
“Mode” link closed
Maintained emergency luminaire circuit (when using Local Controllers)
Or, while connecting Local Controllers and/or K-model maintained or
non-maintained emergency luminaires to a same circuit.
Or, while connecting maintained luminaires without Control function
and K model luminaires to a same circuit
“Mode” link open
Non-maintained emergency luminaire circuit
As factory setting, all circuits are connected as maintained (exit luminaire or Local Controller). If you
wish to change into non-maintained emergency luminaire circuits, the "Mode" link needs to be removed
from those circuits.
Layout for “Mode” links is in next chapter.
NOTE! If you have control type luminaires (model type ends with letter K) or address modules with
maintained/non-maintained selection, all mode links can be closed. Luminaire will be selected
maintained or non-maintained with DIP
–switch. See further information from luminaire’s operation
manual.
5. Connect the alarms and the remote control switch into the connectors shown in APPENDIX 4:
Circuit diagram with 1-phase input and BCM connection and APPENDIX 5: Circuit diagram with 3-
phase input.
6. Set the system date on time so that the automatic tests can take place when scheduled (factory
setting at 00.00 o’clock).