Teknor Industrial Computers VIPer 821, Technical Reference Manual

Page: 99 / 106

BIOS Setup Error Codes
E-7
46-4D Reserved
4E Manufacturing POST Loop or
Display Messages Reboot if Manufacturing POST Loop pin is set.
Otherwise display any messages (i.e., any non-fatal errors that were
detected during POST) and enter Setup.
4F Security Check Ask password security (optional).
50 Write CMOS Write all CMOS values back to RAM and clear screen.
51 Pre-boot Enable Enable parity checker.
Enable NMI, Enable Cache before boot.
52 Initialize Option ROMs Initialize any option ROMs present from C8000h to EFFFFh.
Note: When FSCAN option is enabled, will initialze from C8000h to
F7FFFh.
53 Initialze Time Value Initialize time value in 40h: BIOS area.
60 Setup Virus Protect Setup virus protect according to Setup.
61 Set Boot Speed Set system speed for boot.
62 Setup NumLock Setup NumLock status according to Setup.
63 Boot Attempt Set low stack.
Boot via INT 19h.
B0 Spurious If interrupt occurs in protected mode.
B1 Unclaimed NMI If unmasked NMI occurs, display:
Press F1 to disable NMI, F2 reboot.
E1-EF Setup Pages E1 - Page 1, E2 - Page 2, etc.
FF Boot