Tekno RC EB48 2.0, Building Instructions

Page: 19 / 32

TKR1248 TKR1248
Pull shaft down,
remove screw
THEN
Push shaft up to bleed air,
insert screw snug
(do not overtighten)
Step 1. Insert the four larger o-rings into the emulsion caps and set aside. Install the small o-rings onto
the small emulsion screws by placing the o-rings on a pit mat or towel and pressing the screws into the
o-rings (add 1 small drop of oil onto the seal to help make the screw slide in easier).
Step 2. Fill shock with oil all the way to the top and pump the shock shaft up and down 3-5 times.
Step 3. Screw on the cap all the way tight (shock tool TKR1115 is helpful for holding the shock body).
Be careful to not cross-thread the caps. Start by turning in the oposite direction before tightening.
Step 4. With the shock at about a 45° angle, push and hold the shock shaft to the top of the stroke and
insert the prepared emulsion screw/seal. Oil should leak out during this process. If it does not, add more oil.
Tighten the screw until snug (do not over-tighten). Wipe off excess oil before moving on to step 5.
Step 5. Pump the shock shaft up and down about 20 times vigorously. This emulsifies the oil.
Step 6. With the shock shaft fully extended, remove the emulsion screw from the cap to do the final bleed.
Step 7. With the shock at about a 45° angle, push and hold the shock shaft to the top and insert the
prepared emulsion screw/seal again. Oil will leak out during this process. Finish by tightening the screw
until snug (do not over-tighten).
We've found it's easiest to complete steps 1 & 2 on each shock before moving on to step 3.
By the time you've finished step 2 on the last shock, the first one will be ready for step 3.
Step
1
Step
2-3
Step
4
Step
5
Step
6-7
Prepare caps by
inserting seals
AND
Push small
screws into small
o-rings
(use a drop of
oil to help
prevent a tear)
TKR6714
TKR1248
TKR6714
Fill with oil,
Pump up and down
3-5 times,
Then screw on cap
Fill with oil,
Pump up and down
3-5 times,
Then screw on cap
Pump up
and down
30 times
Pump up
and down
20 times
Push shaft up
to bleed air out
THEN
Insert screw snug
(do not overtighten)
Shock Filling Instructions
For both front and rear shocks
19